Carver Equipment, Hwy 301 South, Dunn, NC  28334
                                          910-892-7171    910-891-7171(fax)  Map to our location.
 Click to return to HOME

Carver, Carver Equip, Carver Equipment Co., Dunn NC, Dunn, Dunn North Carolina, Steve Carver, Carver Kubota,  Kubota Tractor, Kubota Tractor,  Kawasaki, Kawa, Kawasaki ATV, ATV, Mule, Mules, Kawasaki Mule, Gehl, TCM, TCM Loaders, TCM parts, Kubota parts, Kioti Parts, Kubota RTV900, RTV900, Kubota BX24, BX24, Kubota BX1850, Kubota BX2350, Toothbar, WR Long, WR Long Toothbar, Long, Befco, Befco Implements, First Choice, First Choice Implements, Snow Chains, Chains, Generators, PTO Generators, Used Tractors, Used, Used Loaders, Used Backhoes, Gehl Parts, JLG, JLG Parts, Kubota ZD mowers, Kubota mowers, Kubota B21, Kubota L39, Kubota L48, 610, 3010, Mule 610, Mule 3010, Transporter, Mule Transporter, B3030, L3010, DK35, DK45, DK55, CK25, CK30, Kaboat, Kabota Tractors, Kobota, Kobota Tractors dealer


MID MOUNT, side discharge, Mower vs REAR MOUNT FINISHING Mower

 
First ... mid mounted mowers (all with SIDE DISCHARGE) WILL NOT have the ability, no matter how much HP you have to-> " slash through everything without a hiccup"
By design they are made for routine lawn mowing and grooming. 
 
They are not designed to handle EXTREME tall and/or wet grasses and weeds (on the first cut).  In these type conditions, you can raise the deck up higher and clip off the top half of the grass on the first pass.  Allow a little drying time, then on the second /third passes -> lower the deck down to the desired cutting height. 
OR 
In these type conditions, you cheat over to the side and take LESS THAN FULL SWATH with the deck ... allowing the deck to clean itself out much easier.
 
By design they clip the grass for the cut and then allow it to pass through and around the other blades so that the clipping are cut several times before being discharged out the side. 
This allows for a much smaller clipping/debris and therefore a prettier curb appeal JUST AFTER mowing is completed.
 
 
REAR MOUNTED FINISHING MOWERS (with rear discharge) are designed to clip the grass and QUICKLY discharge it out the rear. 
 

This allows for a much larger clipping/debris and therefore a less prettier curb appeal JUST AFTER mowing is completed compared to the side discharge mm mowers.

This allows for a much faster mowing speeds and less clogging.
 
Note.. usually after the first day..... the curb appeal issue is GONE... as the clipping settle down on the lawn surface... Usually on the second day , you can see no difference.